Loosen the motor mounts, jack it up a little in the front and it can be
done. Keep some bandaids close by for the knuckle scrapes! Remove the
radiator though for easier access...
Kent
1960 Bugeye
Subject: crankshaft pulley clearance
> Hello everyone,
>
> Is it possible to remove the crankshaft pulley (and timing cover) with
> the engine in situ? There appears to be less than an inch of clearance
> between pulley and crossmember... I guess using a socket on the pulley
> bolt is out of the question?
>
> Evangelos Makris
> 66 Sprite Mk3
|