"Jeffrey H. Boatright" wrote:
> 1. In case my measurements were wrong, would installing steel wheel
> axles in a wire wheel housing be a go/no go thing? That is, if the
> housing on the car is a one for wire wheels, will the steel wheel
> axles just not fit, or will they fit but be damaged with use?
Jeff
If the steel wheel axles stick out about 3/8 inch, you will have to
change the housing.
More then likely, someone just stuck wire axles in a steel housing.
> 2. Does anyone know where the BL part number is on the axle housings?
> Both of mine are less than clean. I can't find the numbers, but I
> know that they are different for the two different types of housing.
BTA 694 Disc
BTA 695 Wires
--
Frank Clarici
Toms River, NJ
Lots of Sprites
http://www.exit109.com/~spritenut
|