I hope you used a 1300 pound hammer...
----- Original Message -----
From "Frank Clarici" <spritenut at Exit109.com>
To: "Kansa, Robert" <KansaR@diebold.com>
Cc: <email@example.com>; <firstname.lastname@example.org>
Sent: Thursday, October 18, 2001 4:21 PM
Subject: Re: aluminum soldering/welding.
> "Kansa, Robert" wrote:
> > Anyone have any practical experience with this magical aluminum rod that
uses a propane torch with to repair/solder /weld aluminum together with?
> It works OK but watch the melting point of the aluminum you are heating.
> Don't ask about my gate latch that turned into a puddle of melted
> But I have used it to *weld* a steering wheel boss to the wheel, so far so
> good. It stood up to a hammer test because I don't want to find out it
> hold while driving.
> Frank Clarici
> Toms River, NJ