[demime could not interpret encoding binary - treating as plain text]
Exactly. You just said it clearer.
> I agree, but if you had an open on either the primary or the
secondary, or a
> short between the two, you'd sure know it was bad and could chuck it
out without
> further ado.
>
> Geoff Branch
> '74 Meejit "Yellow Peril"
> '72 Innocenti 1300 Mini
>
>
> ----- Original Message -----
> > You could probably eliminate some bad coils with a volt-ohm
tester, by
> > checking for the proper resistance on the primary and secondary
> > windings. However, you wouldn't be able to definitievely say the
rest
> > were "good" because a coil may test fine, but fail under operating
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|