'cept for Frank, in which case in that time he would do the WHOLE job, BOTH
sides,
plus have time for a barbecue and a 12 pack...
anon
:-)
>
>From the "Repair time schedule", "Confidential to BMC distributors" issue
>2, Pub.
>55740
>The following is listed:
>
>Healey Sprite (MKII) and MG Midget:
>Front suspension assembly - complete, remove and refit, one side:
>2hrs 15 minutes
>
>Hope that helps,
>Steve
>
>N wrote:
>
> > Can anyone give me an estimate of the time it should take for a complete
> > rebuild of the front suspension (swivel axles, upper & lower pieces,
>etc.)
> > on an early drum-brake Sprite.
> >
> > I am not a trained mechanic. But, I have rebuilt the front suspension
>of
> > my MGB & it would seem that 20 hours would be more than sufficient for
>an
> > unskilled wrench to do a Sprite. What do you think? If any of you have
>had
> > this done by a shop, your time & cost would be appreciated.
> >
> > Norm Sippel
> > '59 Turner
> > '66 MGB
>
>--
>__________________________________________________
>
>Steve McGee, Atty. at Large
>Samesq@pacbell.net
>Home Page: http://home.pacbell.net/samesq
>Photo Album: http://members2.clubphoto.com/steve191750/
>__________________________________________________
>
_________________________________________________________________
Join the worlds largest e-mail service with MSN Hotmail.
http://www.hotmail.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|