spridgets
[Top] [All Lists]

Re: rock hard clutch pedal

To: <spridgets@autox.team.net>
Subject: Re: rock hard clutch pedal
Date: Sun, 16 Jun 2002 09:45:39 -0400
Update. I have found two different lengths of push rods for the trans slave
cylinder. They are 2 1/2" and 2 11/16" long. There are also two different
slave cylinders available. They are 7/8" and 1" bore. I'm not sure which
combination to use.


> ----- Original Message -----
> From: "Allen Kramer" <allenk@zdial.com>
> To: <spridgets@autox.team.net>
> Sent: Sunday, June 09, 2002 9:30 AM
> Subject: Fw: rock hard clutch pedal
>
>
> > I have experienced the same problem with my sprite. I have a 948 with
the
> > rib case trans. I noticed when putting the unit together that the 948
> > release bearing verses the 1275 release bearing has a different offset.
So
> > thinking since I'm using a rib case trans I would us the 1275 release
> > bearing. Unfortunately, I am having the same condition as described by
> Greg.
> > Not sure what to do next.
> > Al
> > > ----- Original Message -----
> > > From: "Greg Higgins" <higgs@cgocable.net>
> > > To: <spridgets@autox.team.net>
> > > Sent: Saturday, June 08, 2002 12:05 PM
> > > Subject: rock hard clutch pedal
> > >
> > >
> > > > Listers
> > > >
> > > > I had the engine out of my 1098 sprite for some repairs. I put a new
> > > clutch
> > > > disc and throw out being in for good measure.
> > > > I bled the slave, the pedal goes halfway to the floor and then
stops.
> > > > I have tried some adjustments at the master cylinder with out much
> luck.
> > > > My thought is, maybe the clutch disc is binding on the spines of the
> > input
> > > > shaft??
> > > > Any ideas
> > > > Thanks
> > > > Greg Higgins

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>