spridgets
[Top] [All Lists]

Re: Still Soldering

To: spridgets@autox.team.net
Subject: Re: Still Soldering
Date: Sun, 25 Aug 2002 14:15:41 -0700
David,

Get a plumber scratch brush to clean the hole. This is a round brush that
is used to clean plumbing fitting before soldering. They come in different
diameters. I recommend "tinning" each surface before you put them together.
Tinning is flowing solder onto each surface before assembling. This will
assure a complete and watertight seal. This way too, you will also see if
you have problem areas with solder sticking. Shake off any excess solder
one you've tinned each surface to make sure the pieces will still go
together.

Gerard

At 4:35 PM -0400 8/25/02, DLancer7676@cs.com wrote:
>Still trying to solder that da***d tube into the overflow tank on the 1500.
>I heated it this afternoon, melted all the solder out of the joint, pulled
>the tube out about a querter inch.  Sanded it with medium sandpaper to clean
>it up, coated it with plenty of flux.  Replaced it and heated it with propane
>and applied the solder.   It STILL does not want to suck the solder into the
>space between the tank and the tube.  Solder sticks to the tube and the tank,
>but will not flow into that space like it should.
>
>Anybody have any success doing this?  Is there something I am not doing?  I
>am pretty good at soldering copper plumbing fittings leak free.  But this
>poorly engineered POS has me stumped.
>
>--David C.



<Prev in Thread] Current Thread [Next in Thread>