spridgets
[Top] [All Lists]

Re: desperate call for ANY condition pre-64 tonneau(or top if I can g

To: "Gerard" <pixelsmith@gerardsgarage.com>, "Paul Archibald" <androbus@yahoo.com>, "Midget/Sprite" <midgetsprite@yahoogroups.com>, "Spridgets" <spridgets@autox.team.net>
Subject: Re: desperate call for ANY condition pre-64 tonneau(or top if I can get the frame somewhere)
Date: Fri, 8 Nov 2002 13:15:54 -0500
References: <v03130307b9f1ab76d715@[209.209.93.173]>
I just use a piece of plywood with a couple of cleats attached over the
windshield.  The cover then doesn't sag into a puddle.
----- Original Message -----
From "Gerard" <pixelsmith at gerardsgarage.com>
To: "Paul Archibald" <androbus@yahoo.com>; "Midget/Sprite"
<midgetsprite@yahoogroups.com>; "Spridgets" <spridgets@autox.team.net>
Sent: Friday, November 08, 2002 12:59 PM
Subject: Re: desperate call for ANY condition pre-64 tonneau(or top if I can get
the frame somewhere)


> Paul,
>
> Get out your pipe bender and some electrical conduit make a makeshift bar
> to support your cover over the cockpit. It won't cost you more than a
> dollar to do that. That's what I did for my top bows on my Morris, remember?
>
> Gerard
>
> At 7:31 AM -0800 11/8/02, Paul Archibald wrote:
> >As the rain set in before I could prepare, I am screwed
> >again...the poor  '63 midget is sitting under a cover,
> >which I am sure has pooled over teh cockpit and leaked all
> >into there now. I do not have a top or a tonneau or any
> >frame-work for either. was agonna do teh tarp under the
> >cover again like this spring when purchasing it, but that
> >really doesn't work too good...
> >any donations of parts(kidding, but cheap used parts would
> >be welcome as I am still unable to afford much for the
> >beastie)  ANY CONDITION! I can repair anything so
> >rips/tears are not a issue as it's for protection, not show
> >car stuff!  ;-)
> >Heck if there is even a hard-top around not geing used!
> >;-)(wishfull thinking)

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>
  • Re: desperate call for ANY condition pre-64 tonneau(or top if I can get the frame somewhere), Unknown <=