spridgets
[Top] [All Lists]

Re: [midgetsprite] Re: Front Bearing Question-AGAIN!

To: midgetsprite@yahoogroups.com, Spridgets <spridgets@autox.team.net>
Subject: Re: [midgetsprite] Re: Front Bearing Question-AGAIN!
Date: Fri, 29 Nov 2002 11:16:15 -0600
References: <as85tq+ulje@eGroups.com> FILETIME=[1BF5B270:01C297CA]
I have contacted the guy that sold me the bearings and he is getting in an
inner ball bearing so that I will have a matched set. FWIW, there was some
talk about removing the front springs on a Spridget, go to YahooMessenger and
watch the Floundervision extravaganza and see how the PRO's do it!
Brad

Robert Webb wrote:

> A little knowledge is a dangerious thing and I probably have about as
> little as anyone but this setup bothers me.
>
> The inner bearing is a tapered roller which I think as a little hard
> to install backwards, the outer is ball, which I think is
> incompatable.  You can run tapered, I am, inner and outer, but the
> spacer needs shims to fit so the centers are able to be tourqed and
> have the correct tolerance so the bearings turn with out too much or
> too little play.  Ball bearings on the other hand need the spacer and
> I don't think they need shims because their play has been determined
> by the manufacture and is not subject to adjustment by the spacer or
> shims.  They are directional like the tapered and I belive that the
> side with the smaller diameter center would be the "Thrust" side and
> should be towards the spacer.
>
> Using one of each, you have to have clearance for the tapered, and
> none for the ball.  Which bearing do you want to fail?
>
> I think you should run either both tapered or both roller.
>
> Bob, Portland, OR
>
>  >
> >
> > > It is going to be 71* today, getting colder (56*) by Sunday, so I
> am
> > > going to replace the front bearings today. I have a Koyo inner
> roller
> > > bearing and a Beck Arnley ball type outer bearing. Neither one
> has any
> > > markings for "thrust" on it.
> >
> >
> >
> > [Non-text portions of this message have been removed]
>
> To unsubscribe from this group, send an email to:
> midgetsprite-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>
  • Re: [midgetsprite] Re: Front Bearing Question-AGAIN!, Unknown <=