spridgets
[Top] [All Lists]

RE: Vinyl adhesive

To: "'Tim L. Creger'" <timlc@agr.state.ne.us>, "'Spridget list'" <spridgets@autox.team.net>
Subject: RE: Vinyl adhesive
Date: Mon, 30 Dec 2002 14:22:50 -0500
Stick with the 3M Brand, I used an elmer's spay glue first and it let go
after a few hours.  77 worked fine on my interior, if there is a
stronger glue out there then I'd go with that but don't let the long
tack time deter you, spray both surfaces and let them tack up.  There is
not much room for error after that.  Good Luck!

Dan Walters
'63 Sprite
'74 Midget
Brick NJ


-----Original Message-----
From owner-spridgets at autox.team.net
[mailto:owner-spridgets@autox.team.net] On Behalf Of Tim L. Creger
Sent: Monday, December 30, 2002 12:42 PM
To: Spridget list
Subject: Vinyl adhesive


List:

I am making my own panel kit for my '59 Sprite.  I have cut the new
panels and vinyl, but am not sure what type of adhesive will work to
glue the vinyl down to the smooth surface of the panel board.  Anybody
have experience with some "good stuff"?  I have tried 3M spray adhesive
(their "77" rather than their "90"), but it doesn't seem to be quite as
aggressive as need be, and is rather slow to tack up.

Tim C.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>