While rebuilding and changing the differential, I find that when I torque the
pinion nut to only 80 ft lb, I'm putting to much pressure on the bearings. The
only way I can see to get 140 ft lb is to add some shims to the distance
piece. Does any one have a source for 1" ID X 1 1/4" OD X (.001, .005, .010")
shims? Or is there something that I might be missing. Thanks all Rog Smith
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|