Sandy
An old friend of my was named Vernon Brown.
All of the methods you have received so far will work.
I just wanted to caution you to be careful with the threads on the axle,
they are pretty easy to bung up if you are not careful. BTDT but managed to
fix them with a file :-)
Larry Miller
----- Original Message -----
From "Vernon Brown" <vhbrown at comcast.net>
To: "Spridget List (E-mail)" <spridgets@autox.team.net>
Sent: Thursday, September 11, 2003 6:43 AM
Subject: I need to remove the rear hub
> I need to remove the rear hub from my car and do not have tool 18G 146 as
> specified in the manual. I guess I can use a bearing puller I have if I
go
> to the machine shop and get them to make a "plug" for the axle so I have
> something for the puller to push against and go to the metal shop and get
a
> couple pieces of angle iron cut to connect the puller to the studs. This
> sounds like a lot of running around and could get expensive. Is there a
> better way?
>
> Thanks
> Sandy Brown
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|