| To: | "Timothy H. Collins" <thcollin@mtu.edu> |
|---|---|
| Subject: | Re: Clutch Push Rod |
| Date: | Wed, 24 Dec 2003 22:35:31 -0500 |
| Cc: | spridgets@autox.team.net |
| References: | <5.2.1.1.0.20031224203909.00bafa30@email.mtu.edu> |
| User-agent: | Mozilla/5.0 (Windows; U; Windows NT 5.0; en-US; rv:1.4) Gecko/20030624 Netscape/7.1 (ax) |
Timothy H. Collins wrote: > Hi folks, > The hole in the clutch push rod on my 1098 is elongated by at least 1/8 > inch due to wear. I am thinking of filling the hole by brazing and then > drilling it out to size. Anyone else "been there and done that?" I just make a new one with a torch, hammer, and anvil part of the vice using a long 3/8 bolt. cut the head off, heat it red, beat it flat, and drill a 5/16 hole in it. New pin, cut to fit. Happy Healeydays Frank Clarici |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Clutch Push Rod, Unknown |
|---|---|
| Next by Date: | Re: Visit with Jacques Le Clainche, Unknown |
| Previous by Thread: | Re: Clutch Push Rod, Unknown |
| Next by Thread: | Re: Clutch Push Rod, Unknown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |