KGB wrote:
> Are there any secrets, tips, suggestions
Sometimes you have to melt the nylon bushing out.
Try drilling a small hole in it and inserting a screw, then use the
screw to pull out the nylon bushing. If that doesn't work, torch it out ;)
You will need very long needle nose pliers or a long reach JC clip
removal tool to remove the 2nd clip way down inside.
Sometiimes a pair of dental picks works in removing the inner clip.
You also have to drift out a very small roll pin holding the pistons to
a spring. I use a 4d finish nail as a drift.
Getting it apart is tough, putting it back together is a piece of cake.
--
Frank Clarici
Toms River, NJ
|