spridgets
[Top] [All Lists]

Re: [FOT] tr3 alternator/negative ground

To: KENMUN@aol.com, FOT@autox.team.net
Subject: Re: [FOT] tr3 alternator/negative ground
From: Tony Drews <tony@tonydrews.com>
Date: Tue, 21 Feb 2006 22:00:24 -0600
Delivered-to: mharc@demo.fatchancegarage.com
In-reply-to: <24d.717c119.3129013b@aol.com>
References: <24d.717c119.3129013b@aol.com>
Reply-to: Tony Drews <tony@tonydrews.com>
Sender: owner-fot@autox.team.net
Ken, haven't seen any responses to this, so I'll jump in.
I'm not sure what changes have to be made to the starter when going from positive ground to negative ground. If you buy one of Shumaker's gear reduction starters, that problem's solved.

Of course, ground the negative side of the battery. If you are running the ammeter, you'll need to reverse the wires to it, I think.

Take the generator bracket off of the side of the motor, and plug the holes with bolts and sealant - they go through the block and will leak if left open. Use a one wire alternator of some sort (most use the GM, but some use little japanese ones). Bottom attaches to the front of the front plate where the old generator mounted. Put a strap from the front of that bolt to a water pump bolt. You may have to saw a bit off of the alternator to make the pulleys line up. Mine needed about 1/4" - GM one wire alternator. Use stock upper adjustment strap. Put oversized pulley on alternator so it doesn't spin too fast and burn up the bearings. (Moroso or something)

Buy narrow pulley arrangement (crank and water pump) from Gillanders. Run the narrow belt.

Have master switch either cut off ignition or alternator wire. Mine does the alternator wire. I prefer that to the ones that cut off the ignition. But I've heard strong arguments in favor of the opposite.

May have to swap wires on the coil primary so that plus is on the correct side.

The factory radio won't work in this arrangement. :)

- Tony Drews

At 05:01 PM 2/18/2006, KENMUN@aol.com wrote:
fot, what's the advice on changing a tr3 vintage racer to an alternator and
positive gnd?
e.g. do you stay with the fat belt, what do you do for a mtg bracket, what do
you have to change other than the cables to the battery terminals? thanks for
any advice. ken m
===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to majordomo@autox.team.net
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local

<Prev in Thread] Current Thread [Next in Thread>