spridgets
[Top] [All Lists]

Re: Midget E brake links needed

To: <SDOliner@aol.com>, <spridgets@autox.team.net>
Subject: Re: Midget E brake links needed
From: "John D'Agostino" <john.dagostino@comcast.net>
Date: Mon, 24 Apr 2006 21:42:30 -0400
I may have a set on a spare steel wheel axle, I'll take a look and let you
know.

John

----- Original Message ----- 
From: <SDOliner@aol.com>
To: <spridgets@autox.team.net>
Sent: Monday, April 24, 2006 8:06 PM
Subject: Midget E brake links needed


> I just switched from a wire wheel rear axle to steel wheels. The E  brake
> link rods from the swivel assembly to the arm going into the  brake drum
are too
> short. This is for a half elliptical spring axle
>
> Will beg, borrow, trade, steel or buy for a set.
> No reasonable offer will be refused.
>
> Or is there a where to source these from a speed shop? If so, the distance
> from the center of each clevis pin would be appreciated. My guess is a
1/2"
> longer at each side.
> If I could weld, I suppose that I could drill the rods out of the pin
links
> and put in longer rods. But I can't weld.




<Prev in Thread] Current Thread [Next in Thread>