spridgets
[Top] [All Lists]

Re: [Spridgets] Release Bearing

To: Ron Soave <soavero@yahoo.com>
Subject: Re: [Spridgets] Release Bearing
From: "K. Valentine" <kevin@valentinephoto.net>
Date: Mon, 20 Aug 2007 19:17:41 -0400
On Aug 20, 2007, at 6:22 PM, Ron Soave wrote:

> --- David Lieb <dbl@chicagolandmgclub.com> wrote:
>> this: http://tinyurl.com/28ha4d
>> Thousands of trouble-free miles for me.
>
> It's $20+ cheaper on ebay.

Ron,

I have been doing some research concerning the roller bearings.  I  
contacted the seller on eBay.  He told me his bearing is made in the  
USA but REFUSED to reveal the name of the manufacturer.   Peter C.  
also has some experience and advice about certain makes of these  
rollers.

I had a failure within 700 miles with the first roller bearing I used  
(several years ago), so I am a little hesitant to use these again.    
I have recently had the failure of a carbon bearing in Rob's yellow  
Spridget, but that bearing has well over 20,000 miles on it, (it was  
in the car when I got it and we put at least 20k on the car since then).

Until I can find a reliable roller, I think I'll stay with the carbon  
type.

Anybody using a roller?  If so, do you have a manufacturer's name and  
model #?  How long have you had it in service?


Kevin
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>