Your question is unclear. You must not mean the "spring plate." Why
would you grease it?
JohnD
-----Original Message-----
From: BCAH@aol.com [mailto:BCAH@aol.com]
Sent: Friday, August 24, 2007 2:31 AM
To: spridgets@autox.team.net
Subject: [Spridgets] extra grease fitting on suspension
Hello all,----any advice on how to install the extra grease fitting on
the
lower wishbone spring plate? Drill and tap threads,----just drill a hole
and
force it in? What stays put? I have a grease gun with a rubber tip so
maybe
just drill a small hole and pump it in? Maybe use a small cut down bolt
to
screw in to close hole? Any thoughts out there? I am wondering if the
pressure
would blow out the grease fitting. Bob C
************************************** Get a sneak peek of the all-new
AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|