At 08:04 PM 11/4/2007, Phil Nase wrote:
>I could find no specific head nut torque value in my workshop manual for my
>1098 CG motor. The 948 spec was 40 ft lbs so I used that.
>I used 25 ft lbs. for the rocker bracket nuts.
>
>Sound about right?
>
>Thanks.
>
==========
Phil,
Good to hear its going together.
When using the various manuals, Bentley, Haynes, and some
others, you should first look at YOUR engine for the specs. Then, if
none are listed go back one engine, as they only list changes made
since the prior model.
You did it correctly.
Peter C.
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|