spridgets
[Top] [All Lists]

Re: [Spridgets] First drive on new engine

To: pythias@pacifier.com
Subject: Re: [Spridgets] First drive on new engine
From: Daniel1312@aol.com
Date: Sun, 16 Dec 2007 15:29:55 EST
I am aware of that view and even read a long article on it.  However,  it 
only stands as 'good' advice for bedding in the rings and bores.  I've  read 
nothing that suggests it's a good practice for main or con-rod big end  
bearings.
 
My previous engine was successfully revved to 7,500rpm on an almost weekly  
basis despite having a very steady run-in period.  That engine was once  
accidentally revved to 8,250 and survived.
 
The first 100 miles (actually 96) that the engine has been driven was done  
in accordance with the engine builders advice.  He has built a high number  of 
race winning engines as well as fast road engines.
 
Still, your view is as valid as anyone elses.
 
Regards
 
Daniel1312
 
In a message dated 16/12/2007 19:23:04 GMT Standard Time,  
pythias@pacifier.com writes:

Hello  Daniel1312,

others who have done engine  rebuilds will weigh in (never done
one myself)  but all the information that i pick up from
EVERYWHERE is to break it in by driving it like you stole it!
drive HARD, rev all the way up, shift do it again..  apparenlty,
baby-ing during break in can and  often does cause ridges to
build up on the  cylinder walls near the top of the throw.. if
you haven't been red-lining it you may never be able  to!
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>