spridgets
[Top] [All Lists]

Re: [Spridgets] Replacing A -Post

To: James Gruber <thistle_3619@yahoo.com>
Subject: Re: [Spridgets] Replacing A -Post
From: Frank Clarici <spritenut@comcast.net>
Date: Mon, 28 Jan 2008 18:33:26 -0500
Having just done this on my 67, I found the spot welds on the fender 
side of the post, I had my fender off.
I also cut a "U" on the inside of the lower hinges, bent the metal out 
of the way and made a new hinge holder plate.
That part sort of floats inside so you can adjust the hinge.
I have also used a piece of angle iron with the hinge screw holes 
drilled and tapped and just cut it to length and set it inside the post 
and let it float. It worked well and was probably a better design than 
the hinge screw plate, floating bracket to hold the plate, and thin 
metal tap to hold all of the above off the rocker.
As for the post skin, just sheetmetal folded around the corners.
Patch panels are cheap enough but the guts where the rust starts from, 
get expensive and there is nothing expensive in there, it's just unique.
If you cut open the inside, big enough to work in there yet not past the 
post, cut 3 sides, fold the metal up or frontwards, make the repairs, 
fold the metal back and tack weld it. It all gets covered and I do 
believe the open gaps between the welds will let the air get in and dry 
it out so it doesn't rust in the future. Water gets down the windshield 
posts and causes this to rust out.

-- 
Frank Clarici
Toms River, NJ
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>