spridgets
[Top] [All Lists]

Re: [Spridgets] Click-adjust..

To: "Bill L" <pythias@pacifier.com>, <spridgets@autox.team.net>
Subject: Re: [Spridgets] Click-adjust..
From: "David Riker" <davriker@nwi.net>
Date: Sat, 7 Jun 2008 21:53:41 -0700
The different metal parts expand and contract at different rates.  Since you 
opperate the engine hot, that is where the clearances need to be the most 
accurate.  Try this test:  Adjust all the valve lashes when cold to the same 
spec, heat the engine up, and recheck.  They will all be different.  That is 
why they are adjusted when hot.
David R.
----- Original Message ----- 
From: "Bill L" <pythias@pacifier.com>
To: <spridgets@autox.team.net>
Sent: Saturday, June 07, 2008 4:13 PM
Subject: Re: [Spridgets] Click-adjust..

>
>       All that said, i did have a chance to warm up the engine and
>       adjust the valves with feeler gauges instead of the
>       Click-Adjust... hmmmm .. looking for .018 HOT.. had everything
>       from .015 to .O21. So much for consistency with the fancy
>       tool..... so now they're all set to the same thing... next,
>       I'll find out what this setting is COLD so i don't have to warm
>       up the engine first to set the valves..
>
>       and i may have to set the carbs.. the idle seems higher now
>       than before.... .. hmmmmmmmmmm?  !
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>