spridgets
[Top] [All Lists]

[Spridgets] Issues With Grose Jet Carb Float Needle Seat (Longish)

To: spridgets@autox.team.net
Subject: [Spridgets] Issues With Grose Jet Carb Float Needle Seat (Longish)
From: Doug Altman <doug_altman@yahoo.com>
Date: Mon, 9 Jun 2008 17:21:43 -0700 (PDT)
I've had an intermittant problem last year and this with engine suddenly 
running&nbsp;poorly - like no power, pedal to the metal, max. 40 
mph.&nbsp;&nbsp;Sometimes it clears up quickly, sometimes not.&nbsp; Sure, I 
thought it might be stuck float but problem never lasts long enough to be able 
to check.&nbsp; Also, since I put in Mo$$'s Grose jet which they state is a 
"superior replacement for original style needle &amp; seat," I figured they 
should be infallible.&nbsp; So I check dashpot oil, adjust carbs&nbsp;three 
times, replace stock air filters with K&amp;N style to&nbsp;avoid dirty/stuck 
carb plungers, set valves twice, new plugs twice, set timing twice, gapped 
points, new points, condenser, rotor, &amp; cap.&nbsp; All this over the last 
year &amp; problem came back during an 80 mile run over the weekend &amp; would 
not go away this time.&nbsp; I thought - are the valves burned?&nbsp; 
What&nbsp;is going on here?&nbsp;&nbsp;Carb plungers going up
 &amp; down okay. So as engine runs like crap I pull off plug wire #4.&nbsp; I 
have spark between the connector &amp; the plug but engine quits.&nbsp; Put it 
back on.&nbsp; Start engine back up &amp; pull off plug wire #1 - got spark but 
no change in engine&nbsp;rpm.&nbsp; Pulled off wire #2 -&nbsp;got spark but no 
change in engine rpm.&nbsp; I had spark but&nbsp;was running on only the two 
rear cylinders!&nbsp;&nbsp;Put wires back on, spray gas in front carb &amp; 
engine running improves significantly.&nbsp; Front carb is not getting 
gas!&nbsp; Take cap off float bowl and cannot blow through&nbsp;float valve 
even though large ball in&nbsp;valve is free.&nbsp; Tear that "superior" float 
seat assembly apart and there are two steel ball bearings in there -&nbsp;a big 
one which is visible and is moved by the float lever, and a smaller ball 
bearing&nbsp;you can't see because it is hidden on top of the large one 
and&nbsp;seals&nbsp;against the&nbsp;valve seat
 when pushed by the bigger ball.&nbsp; That little SOB is stuck solid against 
the float seat.&nbsp; Had to knock it out with a nail.&nbsp; Put stock style 
float and seat assemblies back in and a drive today showed no problems.&nbsp; 
So, beware of Mo$$ P/N 386-390 Grose jets!&nbsp; (I wish I were a 
better&nbsp;mechanic!)
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>
  • [Spridgets] Issues With Grose Jet Carb Float Needle Seat (Longish), Doug Altman <=