Sounds like the problem must lie in around the points or condenser if it
works when they are not being used.
Thanks
Duncan
-----Original Message-----
From: spridgets-bounces+duncan=pondhop.com@autox.team.net
[mailto:spridgets-bounces+duncan=pondhop.com@autox.team.net] On Behalf Of
Joe Lansing
Sent: Sunday, October 05, 2008 05:05
To: Spridgets
Subject: [Spridgets] coil problem - electrical experts?
I'm fighting an ignition problem. Right now I'm troubleshooting a coil
problem. The coil is brand new. The car has been switched to negative ground
during extensive rework. To test the coil I am trying this: 12 volts direct
from (+) side of battery to (+) side of coil. Hold the high tension wire
(the one that goes to the distributor) just off the block (to check for
spark). Then disconnect the (-) lead from the coil. I get a spark off the
high tension wire, but it appears very weak. And when I re-attach everything
through the distributor I get no spark to the plugs. Any ideas?
Joe
You are subscribed as duncan@pondhop.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.173 / Virus Database: 270.7.5/1704 - Release Date: 10/4/2008
11:35
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|