Wattage would make little difference in the brightness, as they should be
wired parallel, not in series.
Now, if one was a 24 volt bulb versus the normal 12, that would be a
difference!
I would still look first at the ground connection.
Paul A
----- Original Message -----
From: <WeslakeMonza1330@aol.com>
To: <grunthaner@gmail.com>; <spridgets@autox.team.net>
Sent: Friday, August 28, 2009 2:06 PM
Subject: Re: [Spridgets] low light
> I suppose they are the same wattage?
>
> In a message dated 28/08/2009 04:07:16 GMT Daylight Time,
> grunthaner@gmail.com writes:
>
> OK in the AM I'll clean the bullet connectors and use dielectric grease
but
> I am surprised they would give any light at all as I thought with bulbs
in
> general they are ether on or off.
> Lin
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pasgeirsson@worldnet.att.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|