spridgets
[Top] [All Lists]

Re: [Spridgets] Final details....

To: <eap2140@yahoo.com>
Subject: Re: [Spridgets] Final details....
From: "Chris King" <cbking@alum.rpi.edu>
Date: Mon, 9 Nov 2009 15:16:10 -0800
There should be a nipple on one of the carbs near the mounting flange to
the manifold. At least, that's the way it is on the rear carb (HS4) on
my 1500. A series should be similar.

-=Chris

Chris King
http://home.comcast.net/~kvcbk/

<-----Original Message-----> 
>From: Edward Perez [eap2140@yahoo.com]
>Sent: 11/9/2009 4:53:12 PM
>To: spritenut@comcast.net
>Cc: Spridgets@autox.team.net
>Subject: Re: [Spridgets] Final details....
>
>OK, got the horn working! Getting the replacement flasher today, so
hopefully
>have the directionals working tonite. That leaves the "missing at
higher RPMs
>issue." When BillM was trying to set the timing on this, we could not
find a
>vacuum source for the advance on the distributor. We cannot use the
manifold
>vacuum because it is a constant source and it throws the timing off. Is
there a
>location on the SUs or elsewhere that should be used for vacuum
advance? Where
>is this "Normally" hooked up to?
>To: Edward Perez <eap2140@yahoo.com>
>Cc: Spridgets@autox.team.net
>Sent: Sat, November 7, 2009 6:53:16 PM
>Subject: Re: [Spridgets] Final details....
>
>Edward Perez wrote:
>> I'm so amp'd that I'm finally able to drive the Midget thanks to
BillM,
>RickB and Rich Ball. I installed the new starter and she's ready to go.
A few
>minor details that I would like to iron out..... 
>> 1. Missing at 3500 RPM and above...power seems to die off when is
should
>be kicking in (Kent 256 cam).
>> 
>Timing or carbs too lean.
>> 2. No horn (I have to use my finger)
>> 
>
>Fuse? Dead horn? Check the horn itself first, put 12 volts to it and
see if it
>works.
>> 3. No directionals (but the hazards work)
>> 
>At the hazard switch there are 2 solid green wires, they are connected
inside
>the hazard switch, hook those 2 solid green wires together and by-pass
the switch,
>see if the signals work now. Remember have the key on. If not,
check/replace the
>flasher unit, it's NOT the one inside the console, that one is for the
hazards,
>it's up under the dash behind the glove box.
>Or check/clean the contacts on the stalk switch.
>
>
>-- Frank Clarici
>Toms River, NJ
>My own Fleet of Sprites
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as cbking@alum.rpi.edu
>
>http://www.team.net/archive
>
>http://autox.team.net/mailman/listinfo/spridgets
>.
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>