Disk brake bleeders are supposed to be on top; air rises. ...bill in oregon
======================================
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Joe Lansing
Sent: Sunday, December 06, 2009 3:34 AM
To: Spridgets
Subject: [Spridgets] Brake conversion problem
I have converted my 62 sprite to disk brakes up front. I also had a 3/4 bore
master cyl. rebored/rebuilt and I put it in. I cannot get the system to
bleed all the air off entirely. I get firm pedal after 3-4 strokes, but it
won't hold. I have done each wheel cyl. 3-4 times.
Is there a trick to doing the disk brakes? I thought I read somewhere that
they were difficult. Did I install them wrong? The bleeders are at
bottom...any ideas, help, resources?
Joe - of the 3 Year Upgrade Project.
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|