On Sat, May 29, 2010 at 2:34 PM, BJNoSHOV8 <bjshov8@tx.rr.com> wrote:
> Would you check your numbers? It seems unusual that the numbers would have
> 4 significant digits beyond the decimal point. All 3 of these numbers are
> very small.
>
>
> Finally making progress assembling the engine. The challenge of the day
>> is
>> that the camshaft end float is .0125", specs call between .0045" and
>> .0085".
>>
>
O.K., Checked the official BMC manual, cam shaft end float is specified as
.003 to .007 ( took my earlier numbers from Haynes) less clearance than I
originally thought. Still leaves me 5thou over.
Hal
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|