Bill,
Any reason why this would not work on a big Healey also?
Mike MacLean
60 Sprite
56 BN2
--- On Sun, 12/19/10, Bill Masquelier <billmasq@hotmail.com> wrote:
From: Bill Masquelier <billmasq@hotmail.com>
Subject: [Spridgets] Rear seal kit
To: "spridget list" <spridgets@autox.team.net>
Date: Sunday, December 19, 2010, 12:56 AM
Guys
I have been asked a few times about just what the kit is- here is a quick
run-down
The kit comes with instructions-
What this is is a kit that
has a special epoxy that allows you to resize the ring around the
crankshaft (behind the rear main bearing) back to a factory gap of .002"
instead of the .007" or .012" gap that happens when the crank is turned
down by .010" or .020". It requires some handwork but no machining. It
sounds weird but when you have read the instructions you will see why it
works very well.
The cost is $30.00 per kit plus $5.00 per kit shipping. Multiple kits when
shipped together are less since there is no need for duplicates of parts of
the kit (tools and some of the supplies are reusable).
Bill
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/rrengineer.mike@att.net
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|