spridgets
[Top] [All Lists]

[Spridgets] Toyota Troubles

Subject: [Spridgets] Toyota Troubles
From: alan.east-jones at ntlworld.com (EASTJONES alan)
Date: Fri, 29 Jul 2011 09:40:22 +0100
Just catching up on old messages

100 ft lbs  is the same as hanging  100lbs weight off a one foot long
wrench  or 50lbs on a 2 foot wrench 0r 25lbs on a 4 ft wrench (but add a bit
too to be sure )
 soaking  threads with diesel oil or WD40 can help , so can judicial
appliance of heat .
undoing is easy  because you can use a big hammer too - even drilling
through a nut to weaken it first .
tightening  - hire / borrow a torque wrench

it also depends on what the nuts are holding in place  - be careful , very
careful  if  they are restraing a coil spring for example  - attach a
restainer of some sort


Alan  (never owned a Jap car in my life )
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Subject: Re: [Spridgets] Toyota Troubles

Breaking them loose can be the easy part. Get a 6 foot section of 1.5 inch
pipe, slip it over a lifetime warrantee sears ratchet and click away.

No idea how to get the torque set.

Good luck,

<Prev in Thread] Current Thread [Next in Thread>