On Sat, Sep 3, 2011 at 10:13 PM, Andy Webster <a_d_webster at yahoo.com.au>
wrote:
The starter has the adjustable mounting plate, but the only
orientation I can get it to fit gives about 1mm clearance between the
footwell and 2 areas of the starter body. Not nearly enough as the
engine movement will cause a clash. To grind or not to grind at the
new starter motor...?
-------------------------------
This topic has been on the list before. The "we tight" remedy is to
put a couple well placed dimples in the floorpan with a ball peen
hammer.
--
Kent
1960 Bugeye
1983 Garage full of spridget parts!
2010 Arrow shed full of excess spridget parts!!!
|