On Fri, 06 Jun 1997 19:01:07 -0700 Allan Connell <alcon@earthlink.net> writes:
>your test again getting your car up to temp. Check the temp at the
>radiator, then check the temp AT THE SENDING UNIT. Just put your
>thermometer in contact with metal very close to the sending unit and
>you
>will get a fairly reliable reading (help me here guys....). THEN take
>a
>look at your gauge and compare......you may find as I did that the
>gauge is
>bad.
When you "put your thermometer in contact" it will help alot if you use
some "HEAT SINK COMPOUND" silicone grease to make sure you
get a good thermal transfer. It is available at Radio Shack.
Gary
|