tigers
[Top] [All Lists]

Speedometers

To: tigers@Autox.Team.Net
Subject: Speedometers
From: Anita & Jim Barrett <anitabrt@mindspring.com>
Date: Sat, 05 Jul 1997 22:53:12 -0400
At 07:51 pm 7/4/97 -0700, you wrote:
>The speedometer in the Mk1 does not show the proper speed.  As a matter
>of fact sometimes it jumps up to 70 and stays there even when the
>car is not moving.
>I removed the speedo today and cleaned with qtips around the magnets
>in the disc.  I thought maybe there was not enough magnetism thru
>the crud but when I put my variable speed drill on it it still
>wont register.  I can turn the disc by hand and it seems smooth but
>it has some in and out play (approx 50 mils).  
>Any suggestions would be appreciated.  Do I need to take it to a 
>speedo shop or is there something that I need to do to make it 
>functional.  
>
>Thanks in advance
>
>Larry Allbritton
>B9472723
>
        I have repaired my speedometer 2-3 times.  The problems
have been: 1 shaft seized.  2. Wear that allows the magnet to touch
the aluminum cup ( causes the jumping around). 3. the nylon gears
for the odometer and tripmeter cracked from old age.  If you can find
a good speedometer shop then use then and don't waste your time.
Note that if you put in a replacement speedometer cable that is a little
 too long then the speedometer will were very quickly as pressure is 
applied to the guts of the speedometer by the end of the cable.
        For my Alpine I just put in a J C Whitney 3 1/4" 120 mph
speedometer.  I took the chrome rim off the glass of the original
speedometer as well as the black shield and slipped them over the
3 1/4" case .  I then drilled two holes in the original speedometer case
for the two studs at the rear of the 3 1/4" speedometer.  The 3 1/4"
speedometer then fit inside the old case just fine.  Note that I had to
 change the speedometer cable housing fitting to mate up with the 
standard US fitting on the speedometer.  The Alpine speedometer cable
square end is larger than the US version.  I used a Dremmal tool to grind
it down a little then silver soldered it to keep it the wires from fraying.
Grand total cost with shipping about $68.  I am not conserned with the
odometer reading being incorrect as here in Floridia if you are already
over 100k miles you simply state that fact on legal papers.
Jim Barrett Tiger II 351C and others.


<Prev in Thread] Current Thread [Next in Thread>
  • Speedometers, Anita & Jim Barrett <=