tigers
[Top] [All Lists]

Re: Spark Plug Wire Sets

To: Allan Connell <alcon@earthlink.net>
Subject: Re: Spark Plug Wire Sets
From: Steve Laifman <laifman@flash.net>
Date: Thu, 30 Apr 1998 17:53:33 +0100
Allen,

I bought the higher end Accel 8.8 Silicone Wires, with the Spiracore metal
center and radio suppression.  Cost a lot.  These came pre-made for the Ford
V-8, but they didn't label which went where.  Bottom line, they were all too
long for the stock routing.  Wrapped a few around the steering gear, but maybe
that's where they are supposed to go {8->. The end spark plug boots were long
straight cylinders, and I had tro trimm off some of the end rubber to get them
on that last plug.  The distributor ends were pre-bent right angles, and worked
fine.

If I had it to do over again, I would still buy the Accel Spiracore 8.8
Silicone, but this time the "Universal V-8" set with right angle boots at the
plug and distributor.  I 'd crimp the ends on when I've routed them the way I
wanted.

Steve
--
Steve Laifman         < One first kiss,       >
B9472289              < one first love, and   >
                      < one first win, is all >
                      < you get in this life. >


_/_/_/_/_/_/_/
     _/                 _/_/_/       _/_/_/       _/
    _/        _/      _/     _/     _/    _/     _/_/_/_/
   _/        _/       _/    _/      _/  _/      _/
  _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
                         _/
                    _/_/_/



<Prev in Thread] Current Thread [Next in Thread>