I just got my very nice looking 19" x 22" Griffin aluminium radiator (from
Performance bodies for $170) and it will just fit between the cross-member
and the bonnet if I move the radiator's bottom support up to the first tubes
and remove the filler neck. Any ideas, suggestions, comments about putting
the filler neck on the thermostat housing?
I haven't got a header tank and was wondering if I really need one if I put
the filler neck up on the thermostat housing (will that be high enough?) If
I use this set up, any suggestions for eliminating airlocks?
Thanks alot! derek
Zikomo Brewing Company
Box 31730, Lusaka, Zambia
Tel:260 1 286580/85
Cell: 260 1 702694
Fax: 260 1 286585/262810
Life is Short, Drink Real Beer!