tigers
[Top] [All Lists]

Fuel pump volume

To: "'shutchin@netjets.com'" <shutchin@netjets.com>
Subject: Fuel pump volume
From: "Ronak, TP (Timothy)" <Timothy.Ronak@AkzoNobel.com>
Date: Thu, 11 Dec 2003 19:02:16 -0500
I have run into the same problem with insufficient fuel volume. It seems the
factory pump when operating correctly produces 2-4 lbs of pressure and once
hot and under load is not able to achieve that pressure at high engine
demand (+4500). At least on my engine I have the same issue with low fuel
volume so my choice was to upgrade to an Aeromotive Street Rod fuel pump and
regulator. This will ensure that I have the recommended 6 lbs throughout the
RPM range. I will be doing the install over X-Mas. Once installed I am ready
to hit the dyno, ... so is there any others in the Orange County area of
California that want to make an event of this in January or February? 

Best Regards,

Tim Ronak
Business Development Manager
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA  92691 
Off: (949) 305-5393
Fx: (425) 955-6268
Cell: (949) 289-3357
email: timothy.ronak@akzonobel.com 
VM: (800) 234-6747 ext. 2257# 

This message, including attachments, is confidential and may be privileged.
If you are not an intended recipient, please notify the sender then delete
and destroy the original message and all copies. You should not copy,
forward and/or disclose this message, in whole or in part, without
permission of the sender.





<Prev in Thread] Current Thread [Next in Thread>