tigers
[Top] [All Lists]

Re: Headers [FWD FROM DAN WALTERS]

To: RMEbstein@aol.com
Subject: Re: Headers [FWD FROM DAN WALTERS]
From: Steve Laifman <SLaifman@socal.rr.com>
Date: Mon, 25 Oct 2004 10:35:40 -0700
Dan Walters, a terribly successful racing driver of Tigers and others, a 
class AAA mechanic, TigersUnited.com contributor, and developer of the 
rear axle traction rod, has written a response to the question below.

Due lack of quick access to the originator's e-mail address, I am 
forwarding his message (following the reprint question, to the 
originator and the list.

Steve Laifman

RMEbstein@aol.com wrote:

>Mark L. has reminded me of a question I would like to ask.
>
>Sunbeam Specialties offers a set of headers for $255 and CAT offers a set of 
>headers for $325. I was told the primaries on the CAT headers are larger and 
>require some dimpling to fit, whereas the set of headers offered by Sunbeam 
>Specialties fit w/o problem.
>
>Does anyone have any thoughts and also what people have chose for mufflers?
>
>Thank you.
>
>Rodney 
>B382001478LRXFE
>  
>

Dan's Reply:

teve,

  I attempted to respond to the headers issue but do not have the correct
Tiger list address.

can you forward this and give me the address?

DW

Subject: Tiger Headers

Just a note about Tiger headers.

I have installed several sets of the current CAT headers.

I have NOT had to "dimple" the headers to clear the frame 
or motor mounts.

The key is motor position!

Most of the time motor mounts are the problem.

IF, a BIG IF, your car has NOT been hit / damaged in the 
front, the headers should fit.

Don't assume you NEED to dimple them to get them into 
position, IF(BIG) your car has not been previously damaged in 
the front!. 

IF your car have been damaged, fix the car!

If you can't get the headers IN, think about a different 
method before resorting to the hammer!

I have seen headers "dimpled" on one side only to walk 
over to the other side and see excess header clearance!

I do check and "clearance" the headers for bolt fit.

Also, you can get bolts with 5/16 heads.

I have not installed the SS headers in some time, but I 
think the above applies to them also.

Don't ask me to work on your car if you have 12 point bolts
on your headers!!!!

DW  (Dan Walters <spmdr@juno.com>)


-- 
-----

Steve Laifman
Editor
http://www.TigersUnited.com





<Prev in Thread] Current Thread [Next in Thread>