tigers
[Top] [All Lists]

[Tigers] Rivnut

To: <tigers@autox.team.net>
Subject: [Tigers] Rivnut
From: "Ronak, TP \(Timothy\)" <Timothy.Ronak@crna.akzonobel.com>
Date: Mon, 24 Sep 2007 15:52:15 -0400
Listers,

When using this Rivnut tool please note these tips.

After using these on vehicles from the late '70s it is fate that
eventually they will corrode and this will render them virtually
impossible to remove. Further the threads are VERY fragile as they are
made of the same materials as the collapsible portion and are likely
aluminum. Any steel fastener will react with the aluminum making the
virtually impossible to remove in as little as 2 years.

1.      I would ensure that you use anti-seize on the threads to
minimize the aluminum steel reaction
2.      I would abrade the outer surface of the riv-nut and put a small
amount of JB Weld or 3M 4040 on it before inserting into the hole and
then clamp it in
3.      If you do not have the tool you can do it with a long hardened
bolt and a washer and a couple of nuts as well. Be sure to lubricate the
washer to prevent the nut binding on tightening.



Best Regards,

Tim Ronak
Services Consultant

Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691

Bus: 949-305-5393
Fax: 425-955-6268
Cell: 949-289-3357
email: timothy.ronak@crna.akzonobel.com
Personal email: timronak@cox.net
_______________________________________________

Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

<Prev in Thread] Current Thread [Next in Thread>
  • [Tigers] Rivnut, Ronak, TP \(Timothy\) <=