tigers
[Top] [All Lists]

[Tigers] Pulleys

To: "Tiger List" <tigers@autox.team.net>
Subject: [Tigers] Pulleys
From: "Tigerman" <Tigerman67@hotmail.com>
Date: Mon, 3 Dec 2007 11:41:40 -0700
I managed to find a 289 5 bolt short block + heads locally, haven't had a 
chance to tear into it to see if it is rebuildable yet or not, but I paid 
very little for it, so hopefully not a big mistake on my part.

I am missing a few pieces and was looking for some advice.

The short block came missing the timing cover, but I believe I have an early 
style timing cover on the shelf already, but I don't remember which part # 
it is, but I thought it was not the C4AZ-6019-A that I found in the parts 
list.

Was there any differences (that matter) on those early timing covers, or 
should they all be interchangeable?  Most of the references I found just 
mention whether or not the oil filler tube is cast shut or totally removed 
from the casting.

There was also no pulleys with the engine, so I was curious what pulleys I 
should be on the lookout for.  I believe I remember being told that the 
original tiger pulleys were a ford industrial only part and very hard to 
obtain.  The current motor in the tiger looks like it probably doesn't have 
the right pulley setup since the generator doesn't appear to be lined up 
quite right (at least by my eye).

When I went looking at ebay, most used crank and water pump pulleys that are 
out there are poorly documented, and it seems more like you have to ask for 
dimension to be assured what you are looking at.  But I also noticed the 
same part # being listed as different dimensions, which I assume is the way 
that it was measured.  I would assume that Ford would measure from the 
middle of the groove to the back face of the pulley (where the water pump 
touches), but many used parts guys would measure simply the depth (which 
would be the outside of the groove to the back face of the pulley).

So any advise on what the actual tigers were suppose to use (diameter, 
depth, and belt width)
plus what may work even if it is not right (year application?/ possible part 
#/ and/or diameter, depth, and belt width).

Thanks,
Steve
_______________________________________________

Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

<Prev in Thread] Current Thread [Next in Thread>
  • [Tigers] Pulleys, Tigerman <=