I haven't bought any in a few years, but I had purchased a couple at a
hardware store to use as spares for going in from the top side to pick up
the body with a lift while dropping the engine from below. Can't recall any
issue buying them. May just need to find a hardware store with a good fine
thread bolt selection.
Curt Hoffman
Subject: [Tigers] Crossmember bolts
>I am needing four of the 1/2 inch bolts that secure the crossmember to the
> chassis. A friend is also looking for a source for a Lat-79(?) hood.
> I would appreciate any help: Nick
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|