The actuating rods are the same.
----- Original Message -----
From: "Would U. Believe" <mcdangerous@verizon.net>
To: <tigers@autox.team.net>
Sent: Monday, July 12, 2010 9:30 PM
Subject: [Tigers] MKII / Six Bolt Clutch Slave Cylinder Setup
>> Hi all. I have a question about the clutch cylinder setup on the MK2/289
> six
>> bolt bellhousing. I have the MK2 clutch slave cylinder bracket and the
> MK1A9s
>> slave cylinder, so that9s a good start. But because the clutch fork is
>> different from the older 5 bolt housing9s clutch fork, I9m wondering if
>> the
>> 3actuating rod2 from the slave cylinder is also different, or if the
>> 2609s
>> part will work. Does anyone know? Thanks. ( I hope that all makes
>> some
>> sense!)
> _______________________________________________
> Tigers@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/tigers/scattt@verizon.net
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|