http://i796.photobucket.com/albums/yy249/samouce/001-15.jpg
http://i796.photobucket.com/albums/yy249/samouce/002-23.jpg
So I know that Fel-Pro knows what they are doing with gaskets but I am a
little concerned.
Look at pic one and the water passages at the front of cylinder #5. Now
look at pic two with the gasket on, the passages are completely blocked
except for a small hole. The passages at the rear of the block are open.
The smaller passages between each cylinder also have small holes. This is
mirrored on the other side. Is this OK, am I being paranoid?
The head manufacturer (AFR) recommend these gaskets - "Use Fel-Pro #1011-1
for years 1962 -1995".
Someone make me feel better about this.
Duke
B382002037
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|
