[Top] [All Lists]

Re: [Tigers] weather strip

To: "Bates,Robert E Jr" <RBATES@dental.ufl.edu>
Subject: Re: [Tigers] weather strip
From: Tom Parker <tkparker1941@gmail.com>
Date: Mon, 19 Aug 2013 20:39:42 -0400
Cc: "tigers@autox.team.net" <tigers@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
References: <E2B8BB0B3C751543B0F5A21086ACDF7B2665BEA9@AHC-MB04.ad.ufl.edu>

The rubber weather strip on my car is screwed to the drip molding from the
outside, and the drip molding is riveted to the windshield frame. I
probably have the old pictures on a cd somewhere, but they're not with me
in Florida; I remember it was somewhat confusing to figure out which were
rivet holes and which were screw holes; I think the rubber seals determined
which were which.

'67 Mark 2

On Mon, Aug 19, 2013 at 4:25 PM, Bates,Robert E Jr <RBATES@dental.ufl.edu>wrote:

> Hello - I am reassembling my 1966 Tiger after a full restoration, and am a
> little confused about the weather strip that is between the windshield drip
> molding and the door vent window.  Is it just glued to the drip molding?
>  How
> is it orientated?  I'm sure it will be obvious once I'm done, but confusing
> now.
> Pictures of the installed weather strip would be appreciated.  Please send
> to
> rbates@dental.ufl.
> edu>
> Thanks.  Bob
> _______________________________________________
> tigers@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/tkparker1941@gmail.com


Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>