Speedway Motors has them available. www.speedwaymotors.com
They are no longer available from Ford.
Jere
Sent from my iPhone
> On Aug 31, 2014, at 4:34 PM, " Ron Fraser" <rfraser@bluefrog.com> wrote:
>
> Harry
> I believe all Tigers have the spacers; this is normal practice for
> coil spring installation. I think you will also find that a stock Tiger
> will look high in the front; ground clearance and all that.
>
> When I installed my stock springs I used Mustang II spring
> insulators. They are about half the thickness of the stock Tiger one and a
> bit softer. I like the down in front look.
>
> Mustang II insulators - D4AA-5415-A
>
> Since Mustang II style suspension is big in the Hot Rod world, I should
> think those insulators would be easy to find but I don't know for sure.
>
> Ron Fraser
>
> -----Original Message-----
> From: Tigers [mailto:tigers-bounces@autox.team.net] On Behalf Of H B Elam
> Sent: Sunday, August 31, 2014 3:33 PM
> To: tigers@autox.team.net
> Subject: [Tigers] Front coil spacers.
>
>
> When I dismantled B382002027 for strip & dip in 1983 I am sure there were
> spacers (insulators) on both front suspensions between the upper end of the
> coil springs and the cross member, as shown and described on pages MA & MA1
> of the Rootes part manual, publication No. 6600992. Later when working on
> B382000471 I found no spacers. Since I had them, I put them in when the
> suspension went back together. To my uncalibrated eye the front end looks
to
> ride higher than I like. So recently when reviewing the parts list I
> noticed this note for part number P.108521. "From B395000239 Std. and GT
and
> B382000542." Does this mean that some 1A Tigers before B38000542 did not
> have the these (insulators) or am I just chasing my tail, again?
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|