Bill:
You may benefit from talking with Green Sales at 513-731-3304. I have
bought 260 parts from them in the past.
Stephen J. Halbrook, C.P.M., CPIM, CIRM
sjhcobra1@cs.com
1 (813)-681-5248
-----Original Message-----
From: Bill Lawrence via Tigers <tigers@autox.team.net>
To: sunbeam tiger <tigers@autox.team.net>
Sent: Tue, Jul 7, 2015 8:56 pm
Subject: [Tigers] Replacement Thrust Plate Ford 260
Greeetings Tigers
Does anyone have a cross reference part number for a stock config
Camshaft thrust plate with hardware (2 bolts)? Searching for Ford 260 65
Tiger , Early Mustang , Falcon  Ford models results show a couple
versions. The photos for most listed for a 260 have an ear or two cast
around the outside circumference and the one I am replacing  has only
two
mounting ears. I would ideally like to replace the installed (it's
cracked at each ear) with a similar smoother version if possible.
Here are a couple search result links. Â Once again, the list has been a
fantastic resource for the amateur Tiger mechanic/owner. Thanks to
everyone on this list for lending a hand in keeping it running smoothly!
NPD Â
http://bit.ly/1JSMnsH
Found a thrust plate for 289/ THRUST PLATE, CAMSHAFT, .251 INCH TK,
REPLACE IF WORN, C9OZ-6269-AÂ
But the Ears cast into the sides do not
match the currently installed plate.
EBAY
This used item looks closer to the one on my cam and has very similar
guide marks. http://ebay.to/1CZoMSe
Sincerely,
Bill LawrenceÂ
Ft. Lauderdale FLÂ
1965 Sunbeam TigerÂ
B9473246LRX
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/sjhcobra1@cs.com
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|