Iâ??ve used a lot of different gasket material over the years and even made my
own but, for me, cork is the way to go. I apply contact cement to the valve
cover side and thatâ??s it. Makes it easy to remove and replace without using
a new gasket. Never had any leakage problems.
> On Feb 8, 2019, at 7:29 PM, Joe Brown via Tigers <firstname.lastname@example.org>
> I'm looking for recommendations for valve cover gaskets that fit well with
> the LAT 8 covers. The gaskets that came in my set from Fel Pro are molded to
> fit the stamped valve covers and hang way out over the edges of the aluminum
> covers. The LAT 8 covers are flat on the gasket surface so I guess I would
> be looking for something like a flat cork gasket but I'm hoping there is
> something better out there than just cork.
> Joe Brown
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
> Unsubscribe: http://email@example.com
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive