Terry
I believe the Autolite carb is looking for a max of 4.5 psi.
The original SU pump delivered about 2 psi.
You need to check the running fuel pressure to know if you will need a
regulator or a lower psi pump.
Ron Fraser
-----Original Message-----
From: Tigers <tigers-bounces@autox.team.net> On Behalf Of Terry Lawell via
Tigers
Sent: Wednesday, April 21, 2021 3:06 PM
To: tigers@autox.team.net
Subject: [Tigers] Carburetor input pressure
I just put an Edelbrock electric fuel pump on my 66 MK1A with an original 2
barrel carb . The pump had a rating of 4-7psi. At idle it is reading 8.5psi.
I have not yet tested it under load. Is the 8.5psi too high for the float
control valve to operate properly and should i put a regulator on it? Any
input appreciated.
Terry
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|