Jim
This is just a though.
You might possibly TIG Braze a raised P onto the stamped P clamp.
Not sure about this I'm not much of a welder.
I was thinking maybe TIG a brass rod to the shape of the P - sand, file,
sandblast to get the cast look.
You would need to talk to an experienced TIG welder about this.
Ron Fraser
-----Original Message-----
From: Tigers <tigers-bounces@autox.team.net> On Behalf Of James Lindner via
Tigers
Sent: Tuesday, November 09, 2021 3:28 PM
To: tigers@autox.team.net
Subject: [Tigers] WANTED: Original Battery Terminal Clamp(s)
Hello
I am looking for an original Battery Terminal Clamp. I need the Positive (P)
clamp. I will take the N and P clamps, if necessary, although I have my
original N clamp and strap. I have posted this same Wanted message to the
CAT Forum and TEAE FB page without success. There are some aftermarket ones
out there that are close but the P/N are stamped, as opposed to being cast.
Any out there?
Thanks
Jim
Sent from my iPad
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|