Afternoon all, hope you all had a good Chrissy and New year.
>the car I was grabbing/shaking the offending axle when I noticed the bearing
>CUPS sliding ever so slightly inside their bores. The cure is to make up
>shims out of shim stock (usually around .003 to .004) and install them
>inside between the cup and retaining clip (the real cure is to use the
>correct thickness of retaining clip but good luck finding any). Your
>'clicking' will disappear, guaranteed!
John Kipping sells these oversize circlips for about 25 pence each, although I
think it's a bit overkill to buy these from here!!! ;-) There isn't a great
deal of difference in size, I have actually used 2 oversized clips AND a shim
before, perhaps it WAS time for a new yoke after all, I ended up trashing that
yoke when I very childishly <G> did a wheel spin leaving a petrol station and
elongated to holes!!!!