On Fri, 6 Mar 1998, Larry Hooven wrote:
> barrel bracket out so i could put the new one on, i noticed a toggle
> switch on the left hand side of the steering column in the dash,
> further investigation showed 2 12 ga red wires (the kind you buy at
> radioshack) jumbled up and going somewhere (at this point i know not
I had a system like this for reverse lights... the light got ripped off in
an accident (car ended up in ditch)... I plan to install a relay and
sensor on the shifter so a backup light comes on automagically.
> engine cleaner i asked if they had anything in thier entorage of
> cleaning stuff that would remove the greasy finger prints, to which my
> wifes partner said, yea go get the bottle of COMET Bathroom cleaner
> (that's what it say on da bottle) and it should take the grease right
> off. well it does, infact i tested it on the baked on oil inside the
> cover, the stuff that wouldn't come off using an entire can of gunk
> engine cleaner, or foamy brite engine cleaner. spray some on, let it
Read the label carefully, some of these products can't be used on
aluminum. They are powerful bases (opposide of acids) and will readily
corrode aluminum. I have a Craftsman framing square that got left on a
concrete floor too long; the lime in the concrete put large (dime sized)
pits in the blade of the square.
-Malcolm
|